Engine speed rpm
View
Layers rotor · chambers · fire · flows
RPM 3,000 rpm
Real time · 1 : 1 with the engine

R 105 · e 15 · B 80 mm · 654 cc/face · CR 9.7 : 1
Epitrochoid 2 : 3 · 51 / 34 T gears · shaft 3× rotor
Throttlehold to rev

How the

Wankel works

The principle

A curved triangular rotor turns inside a housing shaped like a pinched oval — an epitrochoid. The rotor's three flanks and the housing wall form three sealed chambers whose volume grows and shrinks as it turns. No pistons, no connecting rods, no valves.

The four phases

Intake — a chamber sweeps past the intake port while it expands, drawing in the air-fuel mixture.

Compression — the rotor carries the charge round and the chamber shrinks.

Combustion — near the narrow waist the leading and trailing plugs fire; the expanding gas shoves the flank round.

Exhaust — the chamber uncovers the exhaust port and the shrinking volume pushes the burnt gas out.

Fuel system

AIRvelocity stack INJECTOR+ petrol MIXTURE14.7 : 1 PORT→ chamber fuel line from the brass tank visible through the sight glass

Air is drawn in through the polished velocity stack and the copper runner. Just before the port an injector sprays petrol fed from the brass tank; on older engines a carburettor did the same job. The ratio is about 14.7 parts air to 1 part fuel by mass — so once the petrol has evaporated it makes up only about 1.7 % of the charge by volume. The mixed charge (light blue) is visible through the glass section of the runner before it enters the chamber. Production Wankels run on petrol; diesel versions were tried in the 1960s–70s but never reached production.

One rotor turn, three shaft turns

The rotor rides an eccentric lobe on the output shaft and is phased by a 51-tooth ring gear rolling round a fixed 34-tooth gear. The shaft turns three times for every rotor revolution. Each face completes a full four-stroke cycle per rotor turn, so there is one power pulse per shaft turn.

The sound

Both ports here are peripheral: they sit in the housing wall, so exhaust and intake overlap for a moment. At idle that overlap lets burnt gas spill into the fresh charge and some cycles burn weakly — the lumpy brap. Higher up the pulses come too fast to separate and blend into a raspy, rising buzz. The sound is synthesised live from those pulses.

Strengths and weaknesses

Very few moving parts, no reciprocating mass, compact and light for its power. In exchange: apex-seal wear, a long thin combustion chamber that burns less completely, and higher fuel use and emissions.

Inside a
Rotary Engine
Machining the rotor